About the ME112 Sensing Edge for Commercial Doors

Model #ME112 is designed for use on 1-1/4 to 1-1/2 inch thick doors and are custom manufactured to required length. Our Sensing Edges are designed to provide a safe means of stopping and reversing a door’s motion. Typically powered by just 24 volts, electrically activated Sensing Edges are attached to the leading edge of the door. When touch activated, the internal sensor sends a signal to the motor to stop and/or reverse motion.

How It Works

The ME112 slide in style edge is designed to install easily on most 1-3/8” to 1-5/8” thick sectional doors. Most sectional doors of this size will accept the t-configuration in their existing bottom extrusion- simply slide out the weather seal and slid in the ME112 Sensing Edge. For your convenience, we also offer a variety of mounting channel options for easy installation.

ME112 has been tested with most UL listed commercial operator manufacturers to comply with the UL325-2010 standard and may be used as the required monitored device or as an ancillary device.

UL325-2010 Commercial Operator Compatibility

Safety Standards and Codes for Motorized
Commercial and Industrial Doors:

Effective August 29, 2010, Underwriters Laboratories required that all commercial door operators bearing the UL label are required to be installed with a continuously monitored safety device.

Since 2009, the International Building Code (IBC-2009) has required compliance with the current UL325 safety standard.